Also please check your circular
knife and tab knife requirements

Handhole cutting systems

Characteristic

The Slotterdie system, which has been applied for more than 30 years in order to furnish existing Printer-Slotters with an uncomplicated cutting segment, deserves new attention because of this interest.

In a relatively simple and economical manner, the production possibilities of your current Printer-Slotter can be drastically enlarged.

The Slotterdie system is comprised of 2 segments, namely:

1. The cutting segment which is mounted between the slotting heads on the upper slotter shaft

2. The anvil segment that is mounted on the bottom slotter shaft. On the cutting segment you can where desired, mount a die in order to for example, cut hand- or ventholes.

The anvil segment is comprised of 3 parts, namely:

• Wear-resistant polyurethane cover with steel backing

• The Dicar® bearing, which prevents diecutting on the same place and simultaneously ensures less abrasion of the cover

• Anvil body.

This steel backing ensures that during production the polyurethane does not expand and thus no undesirable tensities take place between the bearing and the cover.

The standard widths of the Slotterdie systems are 75 - 102 - 127 and 152 mm.

In placing several more cutting segments next to each other it is even possible to for example, punch the well-known Swedish lock bottom.

FEFCO No. 0215.

Perhaps you may wish to expand the production possibilities of your current Printer / Slotter.

With this in mind, Dicar has enclosed a questionnaire, which you can complete. We will then provide you with a suitable offer.

1. Split Steel diecarrier with tapped holes for dieform mounting.

2. Clamping plates allow the diecarriers radial movement for register purposes.

3. Typical split anvil head.

4. One piece steel backed cover.

5. Exclusive DICAR® slip bearing.

6. Typical anvilhead.